Home Creators Posts Import Register Favorites Logout

Content

Here's the requested whisp from last week!


Enjoy! :D

Files

Comments

Danny

Ooh this looks like a good challenge and well suited for my new slightly-flexible blend of resin

Cast n Play

How is that working for you? What are you mixing?

Danny

15/85 monocure flex/elegoo grey. I've done a few trial prints so far and it's working really well; preserving detail while adding a small amount of flex for toughness and reduced brittleness so minis are less likely to break when dropped or in shipping. It's well suited to many of your minis as a few have some detailed fragile parts like the fire wizard scythe, blacksmith hammer, caravan weapons etc

Cast n Play

Nice! I'll have to try that out. I drop minis on a daily basis haha

Danny

It's easy to do, and the cost isn't too much extra overall compared to AnyCubic grey. Elegoo grey is good and cheap, and monocure flex is expensive but it's only 15%. Monocure resins do smell worse though - my workshop isn't going to be a pleasant place when I have my entire fleet printing in that mix haha

Cast n Play

I use monocure gray but I didn't notice any drastic change in the smells from the anycubic's resin. Although it's very close to a window and there's a fan as well pointing at it, maybe that's why I don't perceive it.

Robert Maefs

I've been mixing 5% monocure flex with 95% monocure gunmetal. I might even go to 2.5% flex. That's how little I think you need to avoid it exploding if you knock it over.

Danny

Blimey. I'll have to make a few izod impact test pieces at different ratios and test them at work