Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I actually have two Prusa MK2S printers. One got a plastic glob like this and it cost me a lot to fix it due to me breaking the height sensor and temp sensor.
This is the second Prusa and I’m going to try and be more gentle.

You can see the blue temp sensor wires sticking out so at least I can try to work around it. The blob is much smaller than last time so it left the auto level Pinda sensor alone.

Files

Previews only

Comments

Brandon T

Do you have one of those blue silicon socks over-top of your nozzle? If not - and if the Mk3's hot end would allow it, of course - I'd suggest trying that, as it does a pretty good job of stopping plastic from building up on the nozzle. Speaking of the actually issue, however, unless your print settings are really off (which I doubt, if you are running it 24/7), there's got to be something about the geometry of the hot end/extruder that's allowing for this to happen. Maybe you should contact Josef, see what he thinks? Also, do you have your nozzle fan on? I normally don't use mine for the sorts of prints/filaments I'm using, but I've found that even if I don't need it, turning the fan on to the *bare minimum speed that it will actually rotate at* helps prevent material from sticking to/building up on the nozzle, which in turn prevents various print artifacts as well as completely preventing this sort of thing from happening. Unfortunately with my turbofan, even using S3D's "blip fan on start" option I'm still stuck running it at something like 8-10%, which for some materials causes problems, but even so it is a solution you should look in to (if you are not already running a fan, of course).

Karl Nowakowski

Maybe the best way to remove it would be to reheat the hot end and the slowly remove the plastic like swirling honey on a stick.

elproducts

I don’t have a sock on this one but my other Prusa does. I don’t run the fan on the first layer to allow it to stick better.