Success! (Patreon)
Published:
2017-12-07 22:33:31
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
I preheated the nozzle to ABS temps despite it being PLA stuck to the nozzle. I was able to pull most of the plastic away without breaking anything. A wire brush did the final clean up.
I started a new print and the first layer stuck fine. I don’t know why this happens but I just have to be more careful with the Prusa’s.
I may try to design an upside down cone that only allows the nozzle, Pinda and fan air to pass through. That way the plastic can ooze all over the cone but I can just remove it and throw it out with the blob stuck to it and then print a new one. Not sure it can be done but worth a try.
I started a new print and the first layer stuck fine. I don’t know why this happens but I just have to be more careful with the Prusa’s.
I may try to design an upside down cone that only allows the nozzle, Pinda and fan air to pass through. That way the plastic can ooze all over the cone but I can just remove it and throw it out with the blob stuck to it and then print a new one. Not sure it can be done but worth a try.
Files
Previews only