Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I was able to get the second Tevo to print without shifting by reducing the acceleration to 200. It was originally set to 1000. This was done through the Control menu of the LCD.

I decided to try 300 and noticed the first layer was off. As I tried to adjust the nozzle clearance I noticed the loose hotend shown in the video. How I didn't find this originally is beyond me. The bottom idler wheel screw had a chunk of machining shaving stuck in the head so I couldn't tighten it with any allen wrench. Apparently that's why it left Tevo loose because they couldn't tighten it either. I was able to get the shaving out and then tightened and adjusted the hotend offset nut.

I reset acceleration back to 1000 and am trying Phil-A-Ment once again.

Files

Previews only

Tevo Loose Hotend

Comments

Bill Karkula

What were the chances that you would receive one with this issue? Can you imagine how frustrating it would have been if someone new to 3D printing received this printer?

elproducts

True. But then again they might have found it sooner. I’m so used to playing with these I quickly overlook stuff. But the shaving in the allen head screw is clearly a rare occurance. It’s amazing it printed as well as it did.

Anonymous

I would thinhk the shift would be more likely from soemthing too tight or binding. Hope that works as it is an easy fix.