Electronics Design Bench (Patreon)
Published:
2017-12-28 01:04:03
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
I finally spent some time to test out my current electronics design bench setup. Ive shown you my electronics desk with all the component cabinets and my Windows laptop for software and circuit board design. I also close the laptop and use that desk for breadboard wiring or soldering circuit boards.
Next to the desk I also have a long table that holds the iMac I use for all 3D Printing. What I added was a Prusa dedicated to electronic enclosures, brackets or anything else my electronics need printed and the Sienci Mill One setup for cutting circuit boards. I’ll have a video on that in the near future.
Basically from one end to the other and back again is a complete electronic prototype production line. It just needs a little more cleanup and it’s ready to make some projects for CHEP CLUB and eventually YouTube.
Next to the desk I also have a long table that holds the iMac I use for all 3D Printing. What I added was a Prusa dedicated to electronic enclosures, brackets or anything else my electronics need printed and the Sienci Mill One setup for cutting circuit boards. I’ll have a video on that in the near future.
Basically from one end to the other and back again is a complete electronic prototype production line. It just needs a little more cleanup and it’s ready to make some projects for CHEP CLUB and eventually YouTube.
Files
Previews only