Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I recently finished upgrading my Fabrikator Mini. I now have a full graphics LCD on it with SD card slot on the side. I can now print without a computer. I also printed a new base to replace the separate feet and a spool holder. The empty XYZprinting spools fit perfectly on this machine. I've got a lot of cartridges that the Da Vinci told me they were empty but they still have a lot of filament left on them.

I've got this thing printing ABS great. I've been using a raft to make it stick to the Buildtak better. I also switched to slicing with Slic3r instead of the recommended Cura. I'm getting great prints that are stronger and I've been able to print faster. I'm running it at 30 mm/s rather than the suggested 11mm/s. That is a huge speed improvement. I'm getting a little more stringing so I may need a few adjustments yet.


I cheated and printed most of the improvement pieces on my Re-Flashed Da Vinci rather than break it all up to fit on the Mini. I did find someone who took the LCD box and broke it up into 8 pieces that fit together like a puzzle. 


I created a page on my website dedicated to this printer. It's where I'll post any filament settings, firmware updates and any other useful info such as those puzzle piece parts.


http://www.elproducts.com/fabrikator-mini.html


I hope to cover the LCD conversion and print the filament holder on it for the next Filament Friday.

Files

Previews only

Comments

Anonymous

Than little machine is quite impressive! The LCD + SD is a great improvement, and makes it a truly portable tool. How is the Buildtak holding up. i had looked at it but it seemed a bit too expensive. I often damage the painter's tape i have been using when removing a print.

elproducts

Because I cut it into tiny squares, its more affordable on this tiny printer. I would not recommend it though for a larger printer. It doesn't help with prints sticking that much. Where it helps is cleaning of the bed. I put a little glue down before some prints and then have to clean that off plus any left over plastic. I use a razor blade window scraper. If that is blue tape, it would rip. The blade glides over the buildtak perfectly.