MAKERFRONT Printer Update (Patreon)
Content
After the 8 hours of assembly time I still had to calibrate the bed and load the firmware. Yes, I said load the firmware. The printer comes with an Arduino Mega and a RAMPS Shield so some electronics assembly is required. I was a little surprised I had to program the Arduino. Not your typical step for a lower cost entry level printer but then again they don't necessarily advertise that is the market they are going after.
The process went smooth. I was able to program the Arduino and then control the printer through the suggested Pronterface software. I leveled the bed and then the trouble began.
I had installed the optional LCD/SD card unit they sent me, though they don't officially offer it anymore, and decided to try and control the printer from the LCD interface. When I disconnected the USB cable from my computer, the LCD and Arduino shutdown. The board wasn't getting any power from the power supply, just the USB cable. I verified that power was on an the Vin pin of the Ardunio/RAMPS shield at 11.5 volts but nothing on the 5v pin. So I took everything apart figuring the 5v regulator had blown.
After testing it though the Arduino was fine. I could find nothing else wrong so I re-assembled the electronics and powered it up and the Arduino/RAMPS/LCD worked fine. I still needed to screw them back on the frame them so I shut off the power supply and mounted the boards to the frame. I powered up again and this time no power on the Arduino again.
I was so frustrated. Then I realized the power supply green LED wasn't lit. Did I blow the power supply somehow or was it a thermal fuse shutdown?
I waited 20 minutes and tried again. After about 5-7 minutes after I plugged it in, the green LED came on. Incredibly strange. The Arduino came to life and so did the LCD.
At this point I had put another hour in this project and decided to skip the suggested Pronterface, Cura slicer, sample print and small PLA sample and just use Simplify3D and some left over red ABS from a DaVinci to print my typical first print, Chess Pawn. I loaded it on the SD card and started the print at 0.2 layer height, 20% fill, 205c and 90 degree bed temp. The heated bed would not get past 82c so I lowered the setting to 70c. The heat up process was slow but it finally started printing.
The printer was making an awful noise like a bearing was bad. I greased the rods which helped a little but the sound persisted. The print was coming out terrible. The plastic was oozing all over. Then I noticed the extruder motor was spinning too fast. I discovered that the motor was jumping full 1.8 degree movements. That indicated to me that the driver board was bad. I shut it down and swapped the driver board with another. It came with a second driver board for a second extruder (which was not included).
The power supply took another 5 minutes to light the Green LED again and then I tested it and the extruder motor began to work normally.
I re-ran the print and after all that, the print came out incredibly nice. The picture at the top shows the MAKERFRONT print on the left and the Fabrikator Mini on the right. Both with the same settings and same plastic. For this one print it did print as well as the Fabrikator Mini.
So it was a long process and I still am suspect of the power supply but the MAKERFRONT is finally printing. Next up, the rocket print I used in Filament Friday #45 to see how well the very tip of the rocket turns out.
Files
Previews only