Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Just a quick update. The Rocket printed excellent on the MAKERFRONT 3D printer. The tip is about as good as any I've done including the Fabrikator Mini.

Glow in the Dark ABS, 0.2 layer height, 20% fill, S3D sliced, 205c.


Despite its difficult to assemble process and electrical issues I've had, this printer really does appear to print as well as the Fabrikator Mini.


Full picture attached.

Files

Previews only

Comments

Karl Nowakowski

Very good ....... This inspired me to do some test prints on my Wanhao I3 with cura (I don't have simplify 3d). Initially the results where a bit average but then I remembered a setting when I was printing in PLA and though I would give it a shot ...... The results where dramatic and resulted in a near perfect cone and point, dare I say it maybe even better then your fabricator mini. Check out the video, I reakon that it would be worth giving it a shot on your printers, espically the fabricator mini. It does increase the print time but the results are great. <a href="https://youtu.be/tqdgVubinUQ" rel="nofollow noopener" target="_blank">https://youtu.be/tqdgVubinUQ</a>

Anonymous

Thanks for putting up the video. Like the way you charted out the changes as you went through the process. Definitely beats my memory method. Off to print some cones...... just to see if I can get anything remotely close with a Repetier'd Da Vinci 1.0a.

Karl Nowakowski

I made a mistake in the video... The place you need to place 10 seconds into is just on the same screen that you click on to then click the lift head to cool. I tried with 7 seconds to improve print speed last night but the results where not as good.