Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I found some time to unbox and setup the Duplicator I3 that WanHao sent me. Out of the box I already had issues. The chain link cabling had been twisted and broke at one of the links. I was careful in pulling this out so I know I didn't do it. It was also popped out of the base link so this was disconnected when inserted in the box.

The X-Axis rods were pulled completely out of the mount and what a pain it was to get those back in place and secured. The upper mount has a tiny set screw that is incredibly hard to get to. After about 20 minutes of screwing with it, literally, I was able to secure the rods.


Then I went about connecting everything up which went smooth. The wiring is clear and easy. Next I followed the instructions for leveling the bed and wow, what a nightmare. After homing the Z axis, there wasn't enough adjustment left in the spring loaded bed adjustment screws to get any clearance. I found that the Z-Axis stop switch had a second set of screw holes that positioned it higher so I remounted the switch higher and then could get the bed to level. 


Took about 2 hours to get everything ready for the first sample print which was the OK hand seen on many WanHao reviews. It was going great until the hand broke away from the raft and then it became a spaghetti mess.


So first test was not good on the WanHao. This separation from the raft was the same thing I saw on the Monoprice version that I returned. I'll keep testing but first impressions are not good.

Files

Previews only

Comments

Anonymous

Mine was damaged when I received it also (the box even had a hole in it). Both X axis rods were off and one of them bashed into the pulley on the left tearing it from the nut that's welded to the X axis bracket. The Z axis switch was also broken. After repair, thumbscrew and spring cup mod was the first thing I did and now leveling is a lot easier. After a lot of trial and error, I think I have it dialed in pretty well now. I print mostly PLA @210 but also PETG @240 with no problems.

Karl Nowakowski

Based on the reviews I read prior to buying myine is that shipping or possibly quality control seams to the biggest issue with this printer. It is seams common issue given the fact that Wanhao have a series of YouTube videos to solve common faults. Mine had damage on the box so just in case I took photos of the unblocking incase I had to prove to 3dprintersonline that it was damaged during shipping. There was some damage, quite minor, the z axis limit arm was loose (a common fault shown on Wanhao's youtube channel) and some minor damage to the z axis cable chain. Oh and the plate under the heated bed was slightly bent which meant one thumb screw would run out of travel, I just bent this back into shape. I was printing within 30 minutes and still printing well unmodified. There is two things that I have found helps getting the first lay down. First I have set the skirt to do two laps around the object and secondly I use a glue stick for both pla and abs. Don't be afraid to adjust the bed level while printing the first layer, another good reason to do two laps on the skirt. I do get some ripples on corner of a print, doing some reading m3 locks under the bed can improve this by making the bed adjustment screws less wobbly.