Filament Friday #60 - Patreon Early Viewing (Patreon)
Downloads
Missing 1 full-res photo, 1 file, as this post has not yet been imported.
Content
This is a corner shelf based on a scroll saw plan. I was inspired by a large clock I saw, at the Midwest RepRap festival, by Jason Preuss. You can see it in the video. This shelf design turned out nice and I look forward to doing this again at some point with other scroll saw plans. I used the Colido wood filament I received from HobbyKing.com. It printed good but I couldn't get rid of the nerds in the little nooks and crannys. I tried different retraction levels but no luck. I may have had the temp too high but I was at 205C and printed at 60 mm/sec. I ended up having to carve them out with an exacto blade. I couldn't get my finishing tool to fit in most of them as the holes were too small.
The ESUN wood filament (that I used on my cabinet knobs) seemed to printed better than the Colido but the Colido definitely printed with a wood smell. I tried staining the Colido and it took a stain nicely. The ESun didn't have the smell and I haven't tried to stain it yet. May try this again with the ESun.
Enjoy this early release and thanks for supporting my channel.
Files
Previews only