Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I was able to print my Chess Pawn test print in PLA (Green) somewhat successfully on the WanHao. The base just wouldn't stick well (which is strange for PLA) so the bottom is really stringy and uneven. The rest of the print looks really good. I just need to get the bed leveled better. But then I went and screwed that all up by testing ABS (red pawn). After a whole new set of bed leveling I had the same stringy bottom but it printed the rest very good for ABS. I'm beginning to think the Buildtak type surface they included is not as good as the real Buildtak. It seems too smooth.

I had the PLA filament clog on me and I had to take apart the Extruder to clear it out. Not a big deal but what was interesting is after I reinstalled everything, the nozzle was about 1/8" higher and I can't figure out how that happened. I had to adjust the bed up a lot higher and almost had to put the Z stop switch back into the original position. Very strange. I did something to screw that up but don't know what since I never removed the nozzle from its mount.


So I'm making progress but this is clearly not an "out of the box" experience for me.

Files

Previews only

Comments

elproducts

Another great idea to add glass bed. I'll try that.

Joel Telling

Filament jams were fairly constant for me if I didn't load the filament just right. I also found the bed would warp a bit and that's why it was constantly un-level. I was told by someone that the bed would calm down over usage. Unfortunately, I never used it enough.

Joel Telling

I've heard a number of people use the glass from an 8x10 picture frame. They say it works great.