Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

My Fabrikator mini has been letting me down lately. I've had a few prints fail and resulted in some shifting and poor prints. I decided to print my chess pawn as a test case and I had a couple major failures as you can see in the failed pawns above (center and right).

The failure was always in the X-Axis direction so I checked the movement of the bed for any resistance but found none. I then decided to crank up the current to the X-Axis motor by adjusting the reference voltage on the POT from 0.73 to 0.85. This made the motor run hotter but I got the same results. Then while moving the bed looking for clues, I saw that the gear on the stepper motor was spinning at times when the motor shaft wasn't. There is a single set screw on the gear and it apparently loosened up. The motor doesn't have a flattened shaft so the gear could at times just spin. 


I didn't have an allen wrench small enough for the set screw so I had to take the gear off the motor and drive to the hardware store to see if they had anything to fit. Even a 0.050'' allen was too big. I was able to get an eye glasses repair kit screw driver to fit in a cross section of the set screw. This allowed me to tighten up the gear.


After I got the gear back on the motor and the set screw tight I properly routed the belt but couldn't stretch it over the motor gear so I had to cut the tie strap that held the belt tight and in place. I installed a new tie strap after pulling the belt tight. Everything looked good and the movement was smooth so I ran the pawn again and the result was perfect (pawn in left of picture).


I think this has been happening for some time. I've had an occasional print that just didn't print with the same quality I have come to expect from this little printer.  Many people have adjusted the voltage just like I did but it may just be the gears slipping. So if you have one of these, check the gears. They may be slipping.

Files

Previews only