Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I've been looking at ways to make a circuit board with a 3D Printer but since conductive filaments are just not conductive enough yet, I decided to try another conductive glue experiment. This time I imported a simple circuit board layout into Tinkercad and then used those traces to form channels. I then printed it on the Flashforge Dreamer. I manually drilled out the holes for the components and slipped them into place and then connected them using conductive glue. It's drying now. After is dries, I'll sand the bottom to get rid of any shorts and then power it up to see if this works. 

The design has an 8-pin microcontroller so I inserted an 8-pin socket. I'll program the micro to flash the LED. That will be the test of the circuit. I actually designed it to have two LEDs like a train crossing but screwed up and routed the wrong pin to the second LED. So I decided to just test one LED to start.

Files

Previews only

Comments

Anonymous

Hi Chuck, what's the resistance value of the conductive glue? Does it change with the amount you use?