Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

The conductive glue didn't bond to the power leads very well and the resistance of the traces was too high for the microcontroller power input. So this was a failure. It looked good but looks can be deceiving. 

I ordered a conductive pen that has silver in it. I've used one before and have had great success fixing circuit boards with it. Silver conductive ink has a much lower resistance than most conductive inks on the market. Silver is expensive though so the price of a silver conductive ink is in the $20+ range for a small pen full. When it arrives I may attempt something like this again.

Files

Previews only

Comments

Karl Nowakowski

Dumb comment I know. Could you just lay wires in the slots. I know it's not a pcb but it's a neat way of having the wires. The other option which means a bit more work is print a negative. Make a plaster mould then and then poor tin or solder into it which would could then be laid into the the 3D print.

elproducts

Not dumb at all. Others have suggested it. It could be done but my plan is to work towards an automated method so if I can get a good conductive liquid, paste or filament then I can eventually dispense it automatically similar to the way the Voxel 8 printer does (at $8k).

Karl Nowakowski

Could you use the conductive pen on the 3D printer and use the printer like a plotter. There are worked example on how to use a 3D printer as a plotter.

elproducts

I've actually been working on that. I am trying out a circuit scribe pen but the ink just isn't that conductive. The silver content must be too low.