Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I tried several different prints with the Electrifi Conductive Filament from multi3dllc.com but the results are far from exciting. I followed all their slicer settings and printed some conductive test strips. I could not get conductivity anywhere near their advertised 0.006 ohms per cm. I'm seeing 100k+ ohms per cm.

So I contacted them with my results and offered them a chance to help before I give my final review on YouTube. They were quick to respond and gave me many suggestions. The biggest was to use a conductive silver paste to make connections with the filament. They said probing with a meter would not make a good connection. It appears that melting the plastic to the component is what makes the conductive connection. So I tried that and still didn't get better conductivity. They also gave me lots of print results from their own recent testing. They admitted that they have only been selling it for a month and have some things to work out. Even their own testing showed they weren't getting the 0.006 ohms as advertised. They were seeing 15 to 26 ohms per cm which would be outstanding as I'm seeing in the mega-ohm range though I am not using the silver paste contact method yet.

When I take an inch of the bare filament and measure with a meter, I'm getting about 1k ohm per inch, so it is conductive. It's when it gets squeezed through a hot end nozzle that the properties appear to change. I suspect the conductive copper particles are being held up in the nozzle as I've seen some clogging occurring. It also prints as a very low 140c-160c so its very soft.

I just ordered a Circuit Writer conductive pen that has silver conductive ink inside. I've used it before with great results for making circuit board repairs. It has an advertised 0.020 ohms per sq mm but realistically I've seen 10-100 ohm per cm conductivity when it dries. This is still a lot better than any conductive filament.

I'll test the silver conductive pen with the conductive filament but at this point I believe Multi3dLLC is selling false advertising. I hope I get better results soon but at this point I really doubt it.

Files

Previews only

Comments

Brandon T

I agree with Luke; for $120 I'd return it, or at the very least if you do get decent results once you've got the pen I'd still ask the company for a partial refund or some other compensation for your time (and wasted filament - at that price I bet you can count the dollars you'll have wasted).

Anonymous

Sounds like it may only be good for a CapSense type circuit. Certainly nothing requiring even small amounts of current.

elproducts

Agree. I did an iPhone pointer with Inland Conductive which is just a capsense application so I'm sure it could do that.