Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I printed this Statue of Liberty with the Filamentive Copper Filament on my Makerfront before it developed a wiring problem in the extruder (at least I think its a wiring problem). I printed this with supports and they broke away OK but left some nasty gray spots. I found this on thingiverse and had to downsize it to 60% to make it fit so some of the detail was a bit too small to print. It came out decent. I printed at 0.2,  30% fill. There are a lot of little pieces to clean off. Using a brass brush should get rid of some.

It's too fragile to polish on my buffer wheel so I may just sand it. My thought is to use a trick I found online that helps you can make copper form the green patina (oxidized copper) quicker with a mixture of Miracle Grow and Red Wine Vinegar. It's reported to create that look in 24 hours. I haven't tried it yet and may not get to until after NY MakerFaire. So much to do before I leave. 


Anyway, just wanted to share this will you guys to give you a little better understanding of the how this stuff prints. A lot better than I thought.

Files

Previews only

Comments

Karl Nowakowski

I'll be very interested to see how it goes my wife bought me a roll of copper fill filament for my birthday and I've been researching the best way of post processing prints. Colourfab has a tut' were they use steel wool, copper polish and black paint to get an aged copper look and adafruit has video where they use a rock tumbler with brass screws to get a polished copper look.

Anonymous

"a mixture of Miracle Grow and Red Wine Vinegar" Just sounds nasty - will be interesting to see how it works out.