Conductive Filament (Patreon)
Published:
2016-09-27 00:37:14
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
As you guys know I've been experimenting with the conductive filament from multi3dllc and having an incredibly hard time with connections. I printed the design shown with my dual extruder FlashForge dreamer and I was really happy with the results as far as a 3D print but unfortunately, I could never find a way to make a good connection to the traces.
I've talked to their engineers, reviewed the samples they sent me (which all had conductive paste on the ends or had the ends smashed by a bolt/nut with a couple of metal washers). No matter how many times I tried I could not reproduce their results with a conductive silver paste I had. The bolt and nut is something I may try next but it just doesn't seem practical to me for a circuit board. I wanted a way to connect 3D printed traces together but I concluded the surface resistance is just too high with this filament.
They continued to claim that it works by showing me their LED circuit using heat to melt the 3D trace and showed me more test data so I began to question my results. Maybe it was me. Maybe it was my printing technique. Maybe I needed to use a different nozzle diameter. Maybe....
Then I saw the video from Great Scott on YouTube that was recently released. He apparently received a sample spool of the filament and ran it through many tests similar to what I did though he never really tried to build a circuit. After many trials he concluded the same thing. The contact resistance is just too high!
It's always nice to get a second opinion and his is one I trust because he analyzes things similar to the way I do, sometimes deeper. So I've concluded this filament is a waste of money and doesn't match what they advertise. Even though smashing the ends of a strip with a screw and washers can break down the contact resistance and get low resistance measurements, I'm just not sure how it can be used in a practical way with a 3D printed design. If I can't use it in a practical way then I just don't see the need for it. I still have a few ideas based on the screw and washer method but the search for the holy grail of conductive filament for a 3D printed circuit board will apparently continue on.
Files
Previews only