Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Only took about two hours to put it together. The wiring is still loose and I had to add my own Z-Axis screw to get it to home properly but its together. Biggest issue though is the threaded rod. They are M8 and the surface is rough in spots. When I try to raise the carriage, one or both the Z-axis motors stall from the threads resisting. Now I have to take off the motor/rods and see if I can clean up the threads. <br>I'm also concerned about the extruder because it doesn't have a spring release. I guess they expect you to reverse the motor to change filament. <br><br>First impression though, it's seems ok for the price. <br>

Files

Previews only

Comments

Bill Karkula

No spring tension/release for the extruder is unusual. I've built or helped friends to build a few different versions of this style of lower cost 3D printer. The z stop / z-axis usually requires the most time and attention. But after some fiddling, mods, and adjustments, I've always been able to get these printers to print surprisingly well. They seem to need to "wear in" for a few prints and after some fine tuning of printing speeds, etc. , in the slicer they yield consistent quality prints. Regular lubrication keeps them humming. The last tip from my experience and helping friends having trouble removing or changing filament: when removing filament, especially after it has cooled in the extruder and has been re-heated later for removal, is not to pull the filament directly out - release the spring tension and push the filament inwards an inch or so first to melt and extrude the material that was in the heat break and hotend. That gets rid of any filament that may have melted higher then cooled to fill the heat break at the end of a previous print and resists being backed out due to imperfect or rough machining of the interior of the heat break.

Anonymous

I'm a Da Vinci Pro owner (and former Da Vinci 1.0) so I get their emails. Have you heard about their new promotion? buy 12 of their plastic cartridges and you get a free Da Vinci 1.0. I did the math and it comes to paying about $250 for the printer, reasonable.

elproducts

Yeah, they are really getting hurt by the Monoprice printers. I would have rather seen them just update the firmware so the 1.0 is open source like the pro and allow any filament and gcode.

elproducts

Agree, I always push out filament before changing. Its more important for PLA. ABS doesn't expand the same so it's less of an issue.