Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

The $154 CTC 3D Printer doesn't want to extrude plastic at a consistent rate. The gear unit is sealed and doesn't appear to have any kind of spring loaded lever on the idler wheel that rests against the driver gear. I was able to push filament and get it to slip past the gear without the gear moving. I tried tightening the gear assembly to the motor. Tried shifting it to the side a bit. Even tried different filament but the filament barely pushes out at times. This is clearly a weak point of this kit or I just got a bad unit.

Files

Previews only

Comments

Anonymous

this is exactly the same setup as my ctc makerbot clone. It worked for me most of the time but i found i couldnt trust a 10 hour print with it. I recently printed an upgrade for it on thingiverse that spring loads it and it works perfect! It has never failed. If you want to check it out here it is just remember the spring has to be STRONG and provide a lot of force so it pinches the filament to the wheel. I cant actually stop the filament from feeding through with my hand so it works really well. <a href="http://www.thingiverse.com/thing:628019" rel="nofollow noopener" target="_blank">http://www.thingiverse.com/thing:628019</a>

Anonymous

This kit was my first ever printer and it never printed anything. Looking back, this may have been the problem as it never extruded. It's currently sat in a box in pieces so I my have to give it another go.