Home Creators Posts Import Register Favorites Logout

Content

Hey guys, this is just a quick update to let you know that the prototype SSR2 Alpha is now fully designed, up and running. It's one of the most complex parts I have designed so far, so it's taken a while! I will be putting up the complete set of STLs later today, so Makers keep an eye on the part 1 post from earlier this month for that.

The last thing I will need to do is finish my assembly notes, including a wiring diagram, and release the firmware for the device. Look out for an upcoming "part 2" maker post for that. I will also do another livestream before the end of the month showing how to wire up and set up the device.

In the meantime I'm also going to do a short livestream on the discord server in the next couple of hours to show this device off. See you there!

Tempest

Files

Comments

Yomama

Really getting frustrating wasting so much filament on designs that won't fit a FL. I swear I read the release notes carefully on the most recent release and it said it would accommodate a standard FL. Did I somehow misunderstand yet again?

Tempest MAx

The SSR2 is designed for a FeelStroker case, not a standard Fleshlight. it would be hard to design for a Fleshlight because of the way that it mounts. It's also safer. The FeelStroker case can take a Fleshlight sleeve however. I have released a 3D printable compatible case. https://www.patreon.com/posts/february-23-78194730 I am also planning to release a Fleshlight optimised case in the near future.

JustDrwIt

does this use a more powerful motor than the SSR1?

Tempest MAx

It uses two smaller motors, but they are both used for the stroke so the total power is greater.

Gyu

Do you think ssr6 would also use different motors? I'd love to build ssr2 but then I'd throw away these motors same as for ssr1, when ssr6 releases; though if they do share the motors...

chuck

期待你的ssr6