BBQ CONDIMENT HOLDER V2 (Patreon)

UPDATE: NEW SIDE SHELVES FOR LARGER CONDIMENT BOTTLES (UP TO 64mm) 

 Hello my friends!

Here the version 2.0 of the BBQ condiment holder.

Smaller than the first one, faster to print and with some different features, it is a nice complement to the first one!

Its a super easy print, no supports needed and because its a multipart project no need for a multicolor printer!!!

-Can be printed on any 220x220 (or bigger) printer.-All parts already placed in the right orientation.-Easy assembly.-Useful and a nice table center piece for your bbqs.-Color coded file names.-No support needed.-No multicolor printer needed.-Included, step-by-step instructions with exploded views.

Storage for:-Salt and pepper-Toothpicks-2 large condiment bottles (up to 5.5cm in diameter)-Napkins-Extra storage at the bottom, behind the functional doors.

The only part needing a color change is the little meter face. (meter digits). You can do it on any conventional printer with a simple color change at the right layer. If you are not familiar with color change, send me a message and i will help you with pleasure!

HARDWARE: You will need (10x) M3x12mm screws. (M3x10mm screws also works) You can use an imperial equivalent, because the holes are self-threading.

SETTINGS:Nothing special, unless i recommend to use 4 walls (also called shells, perimeters)

I recommend to do a dry fit check before gluing each part. It will help you figuring out each step of the assembly.

In any case, if you have a problem, send me a message. I will try to help you as much as i can as usual!

Have fun, and enjoy your summer!!!

Pascal