FAIRY HOUSES - THE APPLE (Patreon)

Hello my beloved supporters! 

Here's the fourth addition to the fairy house collection! A simple, cute and easy to print apple! 

Just like the others, super easy to print, no supports needed! 

The model is multipart, so NO need for a multicolor printer. Any printer can do it!

All parts are placed in the right orientation for printing, and files have color coded names. 

The assembly is really easy, using small amount of glue. just like the tree others.

The model can be scale to any size, but again the original size is the smallest one i have tested without loosing details. So its possible to scale it up with no proble, but scaling it down may cause some issues.

FOR THE LEAVES: They are flat when printed. Use a little bit of heat (i.e. heatgun) to slightly bend them at the angle you want. You need to print 3 of them. When joined together, the base of the leaves will form a circle. Make a few dry fit tests (without glue) to see if they are bent correcly and where you want each leaves. What i did on my side is to put all 3 leaves in place after bending them, arrange the orientation by rotating them in the carrot body, and then drop a bit of glue in the center to hold them in place.

Detailed instructions are also included in the form of an exploded view.

As usual, if you are experiencing problems with the files and/or your prints, send me a private message and i will try to help you as much as i can! Have fun! I'm going back to the Hot Wheels project...! 

Pascal