WITCH'S BREW CANDY BOWL (Patreon)

Hello fellow makers!

Here's the first model for Halloween 2023!

A classic witch's cauldron, large enough to hold a lot of candies!!!

The cauldron has a diameter of 190mm and a height of (roughly) 150mm.

The broth is the lid of the bowl, and you can lift it by grabbing the large bone on the side.

A witch's broth wouldn't be one without a few eyes! So I have included two models, straight and angled to add a little bit of diversity. They can also be scaled up or down to obtain different sizes, just make sure you are scaling all the parts and using the right ones. More details about the eye assemblies in the instructions.

The design is really easy to print. Even the twisted handles, which have a specific base design to make them really easy to print.

Everything prints without supports, and all the parts are already placed in the right orientation for printing.

The design is made of individual parts, so no need for a multicolor printer.

I strongly suggest to use a brim on the small parts, like the iris and the pupils.

IMPORTANT NOTE: You will find in the stl files, two "broth" files. A normal one (which is the one you can see in the pictures) and one with ripples. If you choose the one with the ripples, it must be printed with the smallest layer height possible,

There's three indentations to glue the eyes in place. You cannot scale the eyes with this version. And you must print three eyes at 100% scale. No more eyes, and not bigger/smaller.

That's why i prefer the flat version (simply called "BROTH"), the one in the pictures, because you can put as many eyes as you want, and in almost any sizes. There's no predefined location with the flat version, and you can be more creative in quantities and sizes.

But i thought you would like to have both version, so the version with the ripples is also included. Choose the one you prefer.

In any case, if you are experiencing some troubles with the files or the design, send me a private message. I will try to help you as much as i can, as i always do.

FILAMENTS: 

-Black: Polymaker Polyterra - charcoal black-Lime green: Spectrum - Lime green-Silver: D3D Sigma - Silver-White: Polymaker Polylite - White-Red: Spectrum - Bloody red-Yellow: Spectrum - Bahama Yellow-Blue: 3DPrintingCanada (house brand) - Baby Blue-Orange: Spectrum - Carot orange

Have fun folks! Keep printing!

Pascal