EYEBALL CANDY BOWL! (Patreon)

Hello fellow makers! 

I hope you're doing well! 

Here's another Halloween candy bowl! And i am totally in love with it! 

With a toonish look, two sizes available and a large capacity, this one will make people talk for sure!

The whole project is easy to print, almost support free, and only one tiny part needs two small supports. (the opening latch at the rear, buildplate supports only, super easy to print!).

The large one was printed with a 0.08 layer height, and the small one was printed with a 0.12 layer height. Both results are fantastic.

I recommend at least 4 walls (5 is better) for all parts. To ensure a good rigidity and prevent breaking overtime.  

Like i said above, two sizes are included: 100% and 75%. They are in a different folder and the file names start with 75p or 100p. So its easy to sort them. 

The iris and the pupill are snug fit inside their cavities. So be sure to prevent any over extrusion.If you have some problem with the fit, try scaling down those parts by 1%. Should be enough to solve the problem. But normally everything should fit nicely. Tight, but nicely. Mine are not glued at all, they don't fall (snap fit) and they can even rotate.

You will need:

(2x) M4x16mm for the 100% model

OR

(2x) M3x12mm for the 75% model. 

All the rest is glued together. 

If you have any kind of questions regarding the project, feel free to send me a private message!

Have fun my friends, Have a nice day!!! 

Pascal