Home Creators Posts Import Register Favorites Logout

Content

Download: HEREIn the zip you'll find the rail files under XZ Plates -> spring model - wheels and rails -> Z rails - mgn12H - setup

This isn't fully tested, as I only had one rail on hand, but my hybrid setup wheels on one side and rails on the other side is working great. so I expect it to work perfectly fine.On the rail side I actually even kept the wheels on the outer part of the extrusions.My printer two left screw behind the X extrusion (what hold the X extrusion and the left motor metal plate ) where very loose, probably been that way for a while, so while you are taking things apart a bit, I would recommend re-tightening those

This is of course still compatible with dual individual motor or mechanically synced setupsI also upgraded my setup from dual 34mm motor (stock Z and stock Y motor) to 40mm motor, and the system holds up really well (with 34mm it was creeping down very slowly)For single motor setup (mechanically synced) I did a test by only installing one 48mm motor, and it held up. just an FYI if you go down that road

If upgrading from wheel setup, you'll need to print new XZ plates, the rail mount, and optionally spacers (or keep the wheels on the outside)addendum BOM:

2x - MHM12H - 300mm

1x - M4x20

8x - M3x6

1x - M3x8 or M4x8 + matching T-nut size

2x - M3x8 up to m3x20

24x - M3x8

24x - M3 t-nuts

 

 

Files

Comments

No comments found for this post.