Home Creators Posts Import Register Favorites Logout

Downloads

Content

The original belt clamp I made (when doing a Y linear rail upgrade) were fine for acceleration under 12K, but had them fail prematurely when testing 16~18KSo these have much better clamping force and a loop for total peace of mind.You don't have to swap them right away, but would recommend you print a spare set at least if you plan on testing higher acceleration, or printing higher temp materialPETG or better (no PLA)

two heat inserts (M3, 4mm long, 4.6mm or 5mm OD)

two M3x12 screws

Has a hole on one side if you have excess belt

 

Files

Comments

No comments found for this post.