BTT Pi 2 + PiTFT50 v2.x + 40x10mm 5v fan — PROTOTYPE (Patreon)

updated Jan13: rev 3 should be safe to print, I printed a rev 2 and found only a very minor issue fixed in rev3

updated Jan12: there was a small area that needed shavingalso tweaked it to be able to optionally add M2.5 washer under the btt pi raising it by 0.5~0.6mm.still not tested -------UntestedFour M2.5 screws (unknown length, likely M2.5x6 or so )Four M3x6 to M3x12 (sandwiched piece)Four M2.5 flat washer or you can also print some attached here with side wallsTwo M3x8 (maybe M3x6) (rear case)Two M3x6 (foot)Four M3x12 (fan)Four M3x17 standoff (supposedly included with screen)5v fan - 4010- add screen to frame- add the sandwiched printed piece- secure the screen with screws (M2.5)- add ribbon cable- secure the sandwiched printed piece to the front case with M3 screws (M3x6 to M3x12)- add M2.5 flat washer under the pi (or use the printed one I provided with side walls making it easier to stay in place)- add pi and secure to the screen using the 17mm M2.5 standoff as screws- connect ribbon to pi video connector.- route the USB C power port now as it  may be easier than later (plus the USB C connector may actually not fit through the hole once closed)- if you want the rear foot, install it now, and secured with two M3x6 from inside the rear case (but check as it may possibly stay in place without screws)- install 5v fan, secure with M3x12 screws, and wire it to GPIO- carefully place the rear case and secure with 4 middle screws M3x8 (if that doesn't work, try M3x6)