Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Over the past two weeks I have been taking a lot of vibration measurements on all the different parts of the frame. I have found that the G5C spherical bearings I am using are causing some vibration that is resulting in poorer print quality and inconsistent layer lines.

I used them in the first place because many other 3D printers have used them in the past, I didn't question it, but when I took a closer look at my print bed I realized that it was over engineered.

These bearings are necessary for Z assemblies based on linear rails because the rails tend to jam if the print bed is not level.

I double-checked my T100 build and found that with linear rods, I can tilt the bed up to 6° without blocking, which is more than enough in practice.

So I got rid of them. The new print bed frame is rock solid. And creates basically no vibration! And it also lowered the price by about $10

This change is already in the alpha1 STEP file, so make sure you use the static print bed over the anti-wobble one.

Files

Previews only

Comments

No comments found for this post.