Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • 343907563.mp4

Missing 1 video, as this post has not yet been imported.

Content

Today I created a basic print start macro for the T250. It uses two TMC Profiles

One for homing, since the TMC5160s have really bad sensorless homing, it took me two days to get to a point where I found driver parameters that allowed me to get consistent homing even as the motors got warmer.

The other is for printing. Here I implemented a fan profile based on the current you give the motors. So for example, if you push 3A on the A/B motors (I know that's about 1A more than the manufacturer recommends), the motor fans will spin at 100% to keep the motors cool as long as possible. In comparison, when running at 1.8A, the motor fans will only spin up to 60% depending on the actual temperature of the motors.

After sensorless homing X&Y, the routine uses the BD sensor to determine Z, followed by a Z_Tilt measurement and a bed mesh calibration. I decided to use a 15x15 mesh because it's more than enough and still takes only 20% of the time my Voron needs for a 5x5 mesh thanks to the real-time probing the BD sensor.

Overall I am quite happy with the results. The homing only takes about a minute and the bed mesh with 0.2mm deviation looks good for an ender 3 print bed (3mm aluminum print bed). Sure the deviation could be better with a 6mm aluminum bed or with a prusa mini bed with separate magnets but hey that's the reason why we do bed mesh.

My next goal is to get the hotend tuned properly so that we can double check if the first layers are on point!

Comments

tanner briton

I'm curious because you suggest in this post you are using TMC 5160 drivers, but in the BOM and initial release post you are using the BTT Kraken main board which uses TMC 2160s. Did you change the main board?