THE 100 Klipper fork (Patreon)
Content
For the past two weeks I have been using danger klipper in the T250 combination and have found two major problems that I would consider showstoppers:
home_current: It's nice to reduce the current for the homing procedure, but since I use pretty aggressive driver settings, it was impossible to home without smashing the toolhead against the frame, resulting in a loud noise. So I went back to my old macro code that overwrites the entire homing sequence
bd_sensor: From time to time the z-tilt procedure crashes the firmware. It looks like there is an incompatibility between the probe and changes in the danger klipper repository. There was an open issue in about this, but at the time I tested it, no fix had been implemented.
So I decided to make my own klipper based on the standard version and pick all the features I like from danger klipper and merge them into my version. This version will be the base for all future THE 100 printers.
Here's the link to my repository:
Files
Previews only