Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Isn't it a beauty? This was my first calibration cube I printed on the T250. As you can see, the z-offset is wrong, the pressure advance is missing, the input shaper is not calibrated, there is a bit of over extrusion soo... guess I need to start tuning the printer.

Files

Previews only

Comments

spacebut

And probably dry the filement

Felix _

What speed and acceleration were used for the print?

The100

I started with 500mm/s at 60k. My goal was to produce the worst possible before so that the after looks even better. Also I wanted to show the community that my prints start as bad as their