Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • 348691778.mp4

Missing 1 video, as this post has not yet been imported.

Content

A viewer pointed out that the Rapido fan duct in the youtube short was in a different place after the speed test. I checked it again and although it feels solid, I have to admit that he was right. So I built a fan duct connected to the extruder by two screws.

The duct in the video was printed on the T250 at 500mm/s and 50k acceleration. There's still a bit of work to be done, but compared to the calibration cube, it's a part I'd say is good enough to assemble on the printer. Yeah, the first layer is still off, don't know what's wrong with the BDSensor, but I'll invest a bit of time to get that fixed.

Comments

No comments found for this post.