Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • 348694257.mp4

Missing 1 video, as this post has not yet been imported.

Content

I noticed that my X/Y Joiners had a bit of flex which combined with nylon fasteners created artefacts on my Y Axis. So I changed them to be a bit beefier, also I went back to steel fasteners. It might be that I try titanium in a later point of time.

Also those parts where printed on the T250 (as every part you will see in the future) Z- is much better, There is still a lot of ghosting on the outer wall since inputshaper is still off. but to be honest i like how that part turned out. The layer lines are pretty consistant, the part is up to 0.1mm accurate, no signs of over/underextrusion. Im happy

Comments

Flo

Looks good! Which accel. and velocity do you use for this print, if I may ask?

The100

I stayed a 500mm/s at 60k acceleration. There is still some issue with my Y Axis causing ghosting artefacts that I have to analyse. But the X Axis perfectly fine, so I would expect that even at 80k or 100k the print would look fine