Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • 208928928.mp4

Missing 1 video, as this post has not yet been imported.

Content

After 5 days of building and over 30 testprints finally everything fits perfectly together. The whole assembly weights 175g. Let's have a look how it will perform

Comments

The100

There is still potential for weight loss, -12g on a 17mm pancake, -4g with titanium screws. -2-3g when printing the extruder out of abs instead of pla

kaifas

How much of a difference in weight is it compared to the Bowden setup?

The100

it's about 80g more compared to the bowden setup. But the bowden is not optimized. For 2.0 i will remove at least one of the fan in favour of 2 120mm side blowers. A 5015 weights 27g a 4010 weighs 18g. The hotend holder weights 11g, the fanducts 63g... im sure that in total the new setup will be even lighter than the bowden, also the weight distribution will be much better which should improve the stability on highest speeds by a lot.