Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Hello Patrons,

In the last few weeks I have been able to make significant progress on the flow rates required for a sub 2 minute speedboat. I was able to melt 320mm3 PLA at 270°C as a maximum flow with a continuous flow of 210mm3. But the higher flows have their trade-offs. Every hotend has it's sweet spot. While 210mm3 sounds like a nice sweetspot, it also means that the minimum flow for this hotend is around 70-105mm3. If you print slower, the hotend boils the filament, resulting in darker pigments on the extruded filament, and it also tends to form bubbles during extrusion, resulting in poor surface quality. All in all it's perfect for a speedboat shredder where you print each line at the same speed as you want to minimise acceleration / deceleration, but it's a bad hotend for normal printing as printing outer perimeters at 100mm3 flow means they have to be printed at 600-1200mm/s depending on the layer height, which will therefore result in artefacts caused by the higher speeds.

For sure I will take it on a ride as soon as all the changes for 2.0 are made.

But this bothered me and I started the calculation for a Hotend that is able to melt 100-120mm3 at max while being able to print also as slow as 20-25mm3.

At the top is my first Prototype of it!

As you can see the melting Zone is about twice as long as a Rapido in it's UHF configuration. It's based on two heaters that will work in parallel with a threaded Connector that includes the CHT Splitter.

In the current version I took a normal knockoff CHT Volcano Nozzle and cut the head of it to use it as a connector of both heaters.

My goal for this Hotend is to use off the shelf parts that are already available so that you can build it on your own.

In the next weeks I will work on that design, optimise it and in the end hopefully be able to share new inside with you in the upcoming week.

Files

Previews only

Comments

Michael Schmitt

Phaetus Rapido Hot-End High Flow - Blue https://amzn.eu/d/1pUiNDB Hey matt you think This normal High Flow is a good alternativ for the chc and fits into your new toolhead ? Thx 😊

Dave

What if the two heaters were used differently for instance when you print slow the top heater is off or at a lower temp than the bottom. When you can rip it both heaters run at the same high temperature.