Home Creators Posts Import Register Favorites Logout

Content

Hi patreons!

As spring is (hopefully) just around the corner, here's an idea for an escape room puzzle that's based around making flowers grow :)

It uses three potentiometer sliders to set the RGB value of a light source via a DMX interface. When the hue of the light matches one of three different-coloured flowers, it causes the corresponding linear actuator to extend, making that flower "grow" up to the light. Players have to make all three flowers fully bloom in order to read a message written on the base of their stems, or to reach and retrieve an item from the top of their stalk, or you can implement any other effect triggered by the Arduino.

I'll be uploading a separate patreons-only post shortly with a link to the Google Drive containing the wiring diagram, code listing, and other resources - please ask if you have questions in the meantime, and enjoy building! 

a.

x

Files

Escape Room Puzzle Tutorial - "Make The Flowers Grow"

In this video tutorial, I'll explain how I created an escape room puzzle using an Arduino UNO to set the correct lighting conditions to make three flowers grow :) The Arduino reads the value from three sliding linear potentiometers, which it translates into an RGB value. That value is sent via a DMX shield to set the colour of a stage light. If the colour matches the colour of petals on one of the flowers, that flower grows up towards the light! This could be used in an escape room puzzle if, once all three flowers have fully bloomed, a message can be read from their stems, or an item retrieved from the tips of the flowers, or any other effect triggered by the Arduino. More details and downloads for this tutorial, and all the other #EscapeRoom projects on this channel, can be found on my Patreon page at https://www.patreon.com/playfultech 00:00:00 - 00:02:39 Introduction and Demonstration 00:02:40 - 00:09:43 Hardware Overview 00:09:44 - 00:15:32 Wiring Diagram 00:15:33 - 00:31:11 Arduino Code Listing 00:31:12 - 00:35:20 Wrapup and Summary #escaperoom #arduino #electronics

Comments

william edgar

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x43 avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x3a avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x5c avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x55 avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x73

william edgar

not sure why , when i download and the dmx is on the uno it gives this error , but when i take it off it downloads

Alastair Aitchison

AVRdude failing to sync normally means you have the incorrect target board set in the IDE. Can you check it says Arduino UNO?