Home Creators Posts Import Register Favorites Logout

Content

Hi folks!

You can access the resources to accompany the "Make The Flowers Grow" project from the following Google Drive link: https://drive.google.com/drive/folders/1KWL-dRu9sjYO16_gl0HqD9GpcEYsCMO5?usp=sharing

This contains the fritzing project (.fzz), the wiring diagram (.jpg), and the Arduino code, together with all required libraries in the "MakeTheFlowersGrow" subfolder. I recommend downloading the entire folder and unzipping it somewhere to your local drive, then running it from there - no additional configuration should be required, so you don't need to do anything with the Arduino Library Manager or anything like that - just load the .ino file into the Arduino IDE :)

Links to hardware used:

Flowers https://www.ebay.co.uk/itm/374754507088

Linear Actuators 8" https://www.ebay.co.uk/itm/124219350197?var=425071581444

8 channel relay https://www.ebay.co.uk/itm/166437372776

DMX shield https://www.ebay.co.uk/itm/165891544761

Please do ask if you have any questions, and I hope you have fun trying it out! 

Comments

Olga Saltovsky

I understand that you don't use optocouplers of relays module. Aren't you have problems with arduino restarts or "frozen" when actuators start to move? Is powering actuators and arduino from different power sources solve it?

Josh Whitrod

Sorry Alastair, complete newbie here. This'll be my first project. What voltage relay module should I be using?

Josh Whitrod

Hi folks. Does anyone know what settings the wash light needs to be on? I've wired up the relay and coded the arduino, but can't seem to figure out what light setting will enable the kit to control the light

Kevin Akat

Hey, I was trying to work on the make the flowers grow project and I have an issue where the relay modules keep resetting every time the potentiometer is set to the target position instead of actually bringing the actuators up. This happens about once every two times I reset the puzzle. any help would be greatly appreciated Thank you!.