Using a standard wood router bit to profile brass. (Patreon)
Published:
2016-06-22 03:48:56
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
Here's a quick clip of profiling the 4 feet that will sit beneath the clock plinth.
Its a standard 2 flute router bit (cove, 12mm radius, carbide tip) cutting 5mm sheet leaded brass with a modest feed rate/DOC and running at max rpm for my little mill (1800). It did a great job, and was a whole lot cheaper than a ball end mill of similar radius.
Interestingly a climb cut gave the better surface finish, which is not what I was expecting. No signs of chatter or "grabbing" of the brass in either direction, and I am sure I could have pushed the feed/DOC much harder without any issue - it ate the stock like it was butter.
Will definitely be doing this again for complex profiling - Expect another short clip tomorrow.
Cheers,
Chris.
Files
Previews only