Single point threading a set of timber screws for the clock base (Patreon)
Published:
2016-06-23 07:51:25
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
These were an interesting little part to make - 8 are required to fasten the feet from the previous post to the timber plinth. The thread form is a 60 degree degree included angle, with a much larger than usual flat at the base of the thread. Tailstock support is from a simple cone runner turned up for the job.
Cheers,
Chris.
Files
Previews only