Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

It's time for a robot dog update!  My Sonic build was mainly created to test the feasibility of the loads cells to make active compliance in the joints, but I'm still not sure how much that will help me. I'm leaving openDog in one piece right now for future development, but while I consider my options with that I'm building a smaller, cheaper, and more accessible robot dog for development.

This version is driven by geared down hobby sized servos which are commonly available, and the rest is 3D printed. Although it's smaller, it's still 12"/30cm to the shoulder joint when the legs are extended, so it'll end up about half the size of openDog when the other axis/body/electronics enclosure etc is designed and built. However it should only weigh in at less than 6kg, NOT 50Kg !

This dog has compliant joints using actual springs and hall effect sensors/magnets to sense the load on each joint - that data is then used to actively drive the motors to make hybrid physical/simulated springs etc - a bit like the robot arm I build a while ago.

I'm planning one additional video for the whole mechanical build, and probably the electronics installation, all being well we'll be onto making it do stuff after that.

Initial joint/leg testing video comes up for Patrons early next week.

Files

Previews only

Comments

Anonymous

Looking awesome! The size sounds perfect for me to build along. The only thing I don't like about servos is their noise - but you got to compromise somewhere ;)

Artype's Halo

Super excited about this James - it's looking excellent!

Cody Blotske

I have almost justified the cost of open dog but this will be much better. I'm excited to build along.

Scott Cress

Ahh! Glad you decided to go with the create a new dog option. 😄 open dog was a complete success as far as I'm concerned. While it may not be in its final form you've created something to inspire everyone. Your next gen Open Dog Mini (ODM..?) will be great. And one I may be able to build.

bruceneely

looking good, more along the lines of what I was going to try to make following your initial build... though glad at this point I wasn't able to follow along at the time

XRobots

I hope to return to openDog, but I don't know if I should rebuild it or keep going!

XRobots

Yes it's all R&D ultimately, unless I build the whole thing and don't put any videos out until it's perfect

bruceneely

well, that would cost you some viewers, I think we like watching the experiments, just excited over the opendog project. I'll just keep sending you a little through Patreon, and see what you manage to develop, until I find a better source of funding :)