Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Performance Robots are getting their 'hands'. I was going to put four fingers on one side so it's more like an actual hand, but i think a simple gripper will be better for challenges using the puppeteering rigs. 

The rigs only have a single switch to active the gripper, so each gripper has a spring and a magnet/hall effect sensor so it can always apply the same tension to what ever it grips, no matter if it's big or small.  There is also a wrist rotation axis on top of the other three arm axes already in the robot.

Of course I have to make everything four times, but it's coming up in a couple of weeks for Patrons!

Files

Previews only

Comments

John N Nelson

I don't understand how a hall effect sensor can be used to limit pressure to different size objects. I'm mostly familiar with hall effect sensors used in keyboards that are off or on. Will yours be used in an analog mode? If the gripper is either off or on will the spring provide the variable tension? If so how is the feedback from the hall effect sensor used? I guess I'll just have to wait and see. You have such great projects. Thank you for sharing your work.

XRobots

Yes the hall effect sensors is analog - into an analog in of the Arduino. However I've just set a threshold in this case. The servo pulls the gripper via a spring, and the hall effect sensor measures the amount of stretch in the spring (the distance from a magnet), so the gripper always stops at the same amount of stretch.

John N Nelson

Okay, that makes sense. I didn't realize the gripper was driven by a servo. I understood your "single switch to activate the gripper" as just an off/on signal and not PWM. That was my misunderstanding. Thank you.