Home Creators Posts Import Register Favorites Logout

Content

Not a bad little unit. This one was surprisingly accurate, although the accuracy will be dependent on the resistor tolerance of both voltage dividers.

I've added more data in the video description on the resistors that could be added internally to load the cells during testing.

The circuitry is interesting because of the way it implements a dual power supply that shares a common regulator. It also has polarity protection on both inputs, with a P-channel MOSFET on the 1.5V input.

https://www.youtube.com/watch?v=RHqACIPPuYU

Files

Inside the Aneng BT-168 battery tester

This unit is a modern LCD version of the classic cell/battery tester. There is one notable difference though, and it is the lack of a load resistor to give an indication of the cells ability to supply current. As supplied, the current drawn by the 9V contacts is about 1mA, and the current on the sliding contact varies with the voltage of the cell as follows:- 1V = 5mA 1.5V = 3mA 4.2V = 1mA If you wanted to add a load, then suitable resistors could be 470 ohm quarter watt across the 9V battery connection point, and a 10 ohm 1W resistor across the sliding contact, noting that the dissipation will be about 1.8W with a freshly charged cell, so a 1W resistor is only rated for intermittent use. The 9V connection point can actually measure up to about 13.5V. I think the most interesting thing about the circuitry is the way it uses a single regulator for both inputs, but boosts one up first. Both test points do have polarity protection - a simple diode on the 9V input and a MOSFET on the low voltage input. As with many of the things I've looked at recently, this one came from AliExpress (not a sponsor). Here's a link to the item. It's an affiliate link, but that will not affect the price you pay. https://s.click.aliexpress.com/e/_c3Qauhph The cost is typically around £2. Supporting the channel with a dollar or two on Patreon helps keep it independent of YouTube's quirks, avoids intrusive mid-video adverts, gives early access, bonus footage and regular quiet Patreon live streams. https://www.patreon.com/bigclive Alternatively, for a single coffee contribution you can use PayPal:- https://www.paypal.com/paypalme/bigclive #ElectronicsCreators

Comments

Phill Rogers

I don't see any programming pins for calibration. Perhaps they program via the zebra strip before assembly?

Big Clive

I'm wondering if it's a fixed calibration value based on known resistor values and a precision reference in the chip. But it is possible that it uses the LCD contacts as inputs before assembly. One possibility for calibration might be applying a precise voltage to both inputs simultaneously, detecting that both voltage divider inputs are active simultaneously.

adorfer

the "analogue meter" variants of this device have a dedicated load resistor, which put at least some load on the battery, not to rely on the possibly misleading V0 of a "recovered" (but actually nearly empty) cell. I would suggest a mod to with 3 buttons to put 1k/300/50Ohms load. (or a 4pos switch with open/1k/300/50 positions)

Dave Frederick AKA @amorphuc

Wow! Thanks Big Clive! I've had one of these for a while and had no idea about the circuitry inside. It's much more complicated than I would have thought. Too cool.