Halloween Mask - Magnetic Fidget (Patreon)

This is a Print-In-Place Magnetic Fidget design. If you print the attached 3mf file the build will pause at layer 30, at which point you can easily insert (6) 8x3mm neodymium magnets into each half. Remember to reverse the magnet polarity between the two sides. This is the same 2x3 pattern as the King and Ace Fidgets.

For the best movement and fidgeting experience I highly recommend printing these on a textured build plate.

The magnets I used were purchased from Amazon, link below….

https://linktr.ee/mzmdigitaldesign

These were printed on a stockBambu Labs X1C and P1S

0.4mm nozzle

0.12mm layer height

Infill: 50

As always please let me know if you have any questions! Thank you!

Mike