Plain Faced Magnetic Fidget_2x3 Pattern (Patreon)

Some of you have reached out and asked for a plain faced fidget with the 2x3 Pattern (Same pattern used in the Kings and Aces) with the graphics removed so you can customize them or print them against your favorite PEO patterned build sheet.

For optimal fidgeting performance the bottom closure plate should be printed against a textured build plate, in my opinion.

Each side has (6) 8x3mm neodymium magnets pressed into the holes, I use an arbor press for easy assembly. Remember to reverse the magnet polarity between the two sides.

The magnets I used were purchased from Amazon, using the link below….

https://linktr.ee/mzmdigitaldesign

I have a few designs I am so close to finishing that I am looking forward to sharing, one of them by the end of this week.

As always please let me know if you have any questions! Thank you!

Mike